Stainless Steel

Surface critical stainless stampings from .010 to .100 thick are embossed, tapped and in-die assembled using progressive or stage dies. We produce exposed stainless parts without surface defects, on time and to your specification.

	Thumb tool An embossed hand tool that is curved to fit the thumb. Embossing provides durable advertising for this retail manufacturer using either brushed or bright finish stainless.
	Retaining clip A retaining clip for an electronic frame is from 301, full hard stainless. This part is 3/4" long with two 1/8" legs and is produced in a progressive die.
	304-2B Bracket These two surface critical parts are punched and formed in a progressive die.
	Barrel hinge Precision tolerances are needed to draw the door in and prevent leakage in this outdoor hinge application. Note how close the countersunk hole is to the edge of the part without producing distortion to the adjoining edge.
	Latch parts 12ga 3042B parts must be parallel and precise to produce a part that does not wobble. Competent die design and quality inspection and monitoring by our operator is a necessity.
	Latch parts These parts exhibit embossing, coining, or tapping. All parts are surface critical.